Automatic GDO-9v2 SecuraLift Manuel d'installation télécharger pdf (Page 28)

GDO-9

Owner Installation Instructions

ﬁ g

Final Setup

Step 23 - Setting of Courtesy Light Time

The preset courtesy light time is three minutes. This time

can only be changed by “PG3” programmer.

Step 24 - Setting the Pet Mode position

The default Pet Mode height can be changed as follows:

Make sure the door is closed, then press and

hold the OPEN button for six (6) seconds (Fig.

46), until you hear three beeps and the OPEN

and CLOSE LEDs ﬂ ash rapidly.

Press the OPEN button to move the door to the

desired Pet Mode open position.

Press the SET button to record the new position.

When activated, Pet Mode drives the door to the preset

position from either above or below. Pet Mode’s active

status is indicated by both the OPEN and CLOSE LIMIT

LEDs being illuminated. If a Pet Mode button is pressed

while the door is moving the door will stop. If a Pet

Mode button is pressed when the door is in the Pet

Mode position, then the door will close.

Step 25 - Installing the Wall Mounted

Transmitter (Optional)

Remove the faceplate from the transmitter.

Afﬁ x the baseplate in a convenient wall location

that is out of reach of children and convenient

to the customer (Fig 47). Make sure the door is

visible from this location.

Replace the faceplate.

To code the transmitter, see Steps 18.1 through

18.5 on page 21 and 22.

Step 26 - Reset all Factory Defaults

Turn power to opener off.

Press and hold the SET Button (Fig 48).

Turn power on while holding the SET button.

Continue to hold until all the LED’s are off.

This will not erase transmitter codes stored in

memory.

ﬁ g

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Automatic GDO-9v2 SecuraLift Manuel d'installation Page 28