Automatic GDO-9v2 SecuraLift Manuel d'installation télécharger pdf (Page 15)

Owner Installation Instructions GDO-9 15

WARNING: The opener must be securely

fastened to structural supports, otherwise opener

failure may ensue causing serious personal injury

and/or property damage.

Step 3 - Determine Bracket Position

Open the door and ﬁ nd the highest point of travel of

the top door panel.

Using a level, transfer this height to the wall above

the door (Fig. 10) and mark a line 60mm above it.

Determine the centre point on the wall above and on

top of the door. Draw two lines extending 21.5mm

from each side of the centre point. (Fig. 11)

Step 4 - Mounting the Wall Bracket

Centre the bracket over the intersection of these two

lines. Mark centres for at least two holes (Fig. 11)

and ensure it is into a solid mounting point.

Drill holes into the wall with an appropriate bit.

Secure to the wall using:

IF CONCRETE OR BRICK - 8mm (5/6”) loxins/dynabolts.

IF TIMBER - wood screw #20 or similar (min. 50mm).

WARNING: Make sure concrete, brick wall or

timber lintels are solid and sound so as to form a

secure mounting platform.

Step 5 - Attach the Rail to the Wall Bracket

Attach the C-Rail assembly to the wall bracket

with the 90mm long clevis pin and secure with the

supplied snap pin (Fig. 12)

Leave the drive unit in its packing box for protection

during installation.

Step 6 - Secure the Drive unit to the Ceiling

Raise the drive unit from the packing box and support

it in the horizontal position with a step ladder.

Open the garage door. Rest the opener on the open

door and use a scrap piece of wood to bring it to

horizontal level.

Line up the track perpendicular to the wall.

Secure the perforated angle (not supplied) to the

ceiling above where drive unit’s mounting holes will

be once fully installed. A representative mounting is

shown (Fig. 13)

Connect the drive unit to the ceiling mounted

perforated angle with M8x20mm screws and nuts.

Strips should not extend more than 18mm below

centre of drive unit mounting holes.

Go to Step 11 on page 17.

ﬁ g

Track

Door

Track

Level

Door

Drilled holes

Mounting on a Track Type Door

ﬁ g

Structural member

21.5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Automatic GDO-9v2 SecuraLift Manuel d'installation Page 15

Commentaires sur ces manuels