Automatic GDO-9v2 SecuraLift Manuel d'installation télécharger pdf (Page 16)

GDO-9

Owner Installation Instructions

WARNING: The opener must be securely fastened to

structural supports, otherwise opener failure may ensue

causing serious personal injury and/or property damage.

Step 7 - Determine the Door’s Centre

Find the centre of the door and mark this location

both above the door and on top of the door.

Draw two lines 21.5mm either side of this (Fig. 14).

Step 8 - Prepositioning the Opener

Raise the door to open position.

Rest the opener on the top edge of the door with

end of the rail against the wall (Fig. 15).

Support the drive unit level with the lowest point of

the open door (Fig. 15).

NOTE: Do not slide rail along the face of the door.

Step 9 - Mounting the C-Rail

Close the door slowly. The rail will be elevated by

the top edge of the door as it moves.

Stop the door when it is at its highest point of travel.

Allow 25mm additional height for clearance between

the door and the track (Fig. 16).

Support the Rail in this position and close the door

The height determined in Step 10(b) will be the

height at which to mount the wall bracket.

Centre the bracket along the line determined in Step

Using the bracket as a template, mark a minimum of

two holes and drill with appropriate size bit. For a

more secure ﬁ tting, the wall bracket can be anchored

using more than two holes.

Secure the bracket to the wall using:

IF CONCRETE OR BRICK - 8mm (5/6”) loxins/dynabolts.

IF TIMBER - wood screw #20 or similar (min. 50mm)

Attach the bracket and C-Rail with supplied pins (Fig. 12).

WARNING: Make sure concrete, brick wall or

timber lintels are solid and sound so as to form a

secure mounting platform.

Step 10 - Secure the drive unit to the Ceiling

Secure the perforated angle (not supplied) to the

ceiling above where drive unit’s mounting holes will

be. See (Fig.19) for a representative mounting.

Connect the drive unit to the ceiling mounted

perforated angle with M8x20mm screws and nuts.

Strips should not extend more than 18mm below

centre of drive unit’s mounting holes (Fig. 13).

Step 10.1 - Alternative Mounting Option

The opener can be fastened to the roof by driving a bolt

through the C-Rail into a structural timber support. The

bolt head’s height must not exceed 6mm (Fig. 17).

ﬁ g

Centre of Door

Mounting on a Spring Loaded Door

ﬁ g

Step

ladder

Step

ladder

C rail

Door

Highest point

of door travel

Drill hole at centre of

track (recommended

bolt size M6 or M8)

Ceiling

Aluminium rail

Shuttle VP2 assembly

ﬁ g

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Automatic GDO-9v2 SecuraLift Manuel d'installation Page 16

Commentaires sur ces manuels